|
Alcino Magnet Motor by Ron Viellieux
Update on AlNiCo permanent bar magnet motor tinkering
From: Ron
J Viellieux
Sent: Friday, September 12, 2003 7:18 PM
Subject: Update on all permanent magnet motor
Here is update on my input I wrote you a few months back, about my dad had AlNiCo permanent bar magnet orientation that pulled and pushed a rotor past the magnets 45 degrees. My dad wanted to use stronger magnets, I wanted to use same type magnets but put them around the rotor and stator. My update is long winded so I attached the report, as an htm document and a word doc. If you have trouble with my vayoutech@juno.com address try my new one, guyiam80@yahoo.com Regards, Ron Viellieux
From: <Ron.J.Viellieux@seagate.com>
Sent: Tuesday, September 23, 2003 1:17 PM
Subject: FreeEnergy.GreaterThings.com
Contact
I have had some feedback and found an error in my notes to you. I said my dads model, the rotor turned 45 degrees after the stator magnets and next I should put 5 rotor magnet sets on so the next rotor magnet would catch the next set. 45 degrees is wrong. The rotor spun a little over 90 degrees after the stator magents, which is even better. A little over 1/4 of a full turn. Then the 5 rotor magnets would make sense. Regards, Ron Viellieux Office 952-402-8993
From: <Ron.J.Viellieux@seagate.com> Hi Mr. Allan, Anyway, my Dad put 2 Alcino magnets together in a certain alignment on a stator and 1 Alcino magnet on a rotor with a certain alignment (8" Al disk) and the magnet on the rotor was pulled into then shot out of the 2 magnets aligned together on the stator. The rotor turned over 45 degrees when it went past the stator magnets. So we are getting a bunch more Alcino magnets to put all around the stator and rotor, from what I saw, this all permanent magnet motor should run by itself. I was just excited and had to tell you. As soon as we add more magnet so the rotor will turn completely, I will draw up the magnet alignments and take some pics for you to share with everyone. We are not interest in getting patent (if we could get one at all) and we want public to see it. It is extremely simple to make. My Dad wants to get stronger magnets but I am telling him to finish the
Alcino magnet prototype first. I don't believe this works on zero point
energies, I would say it is purely attraction and repulsion. The magnets
are aligned a certain way, it's pretty cool. Sorry, just excited about it.
more info on this as soon as I can.
See also
Contact
Page posted by SDA
July 15, 2003 |
|
|
